Please take a moment to familiarize yourself with SUN-SLIDE before installation.

Click on the diagram for a larger view...

Step 1

Prepare the sun visor

Flip the sun visor down, and unclip it.

Step 2

PREPARE SUN-SLIDE FOR NEXT STEP

Slide SUN-SLIDE over the end of the sun visor so it can be shaped in Step 3.

Step 3

SHAPE SUN-SLIDE TO THE SUN VISOR

Using your left hand on the top edge, and your right hand on the bottom, squeeze SUN-SLIDE along the built-in scores (A) to shape it to the sun visor's top and bottom edges.

Step 4

Remove SUN-SLIDE

Using your thumb and forefinger, pull SUN-SLIDE off the visor and place it in your lap for Step 5.

Step 5

Insert Tabs

Insert the two tabs (B) into what you think are the best-fitting slots (C).

Step 6

Test Fit SUN-SLIDE

Put SUN-SLIDE back onto the sun visor, but do not force it. If SUN-SLIDE fits too tightly or loosely, go back to Step 5 and adjust the tabs (B) accordingly. A correct installation looks like the picture in this step, folded along two or three scores at the sun visor's top and bottom edges, producing a snugly loose fit.

Step 7

Installation Complete

You have now completed the installation of your SUN-SLIDE! Here, two SUN-SLIDES are stored-up, ready to be deployed to either side window.

Step 8

Position Your Visor

Position your sun visor to the side window. SUN-SLIDE is now installed, but not yet positioned rearward

Step 9

Position SUN-SLIDE

SUN-SLIDE is installed and positioned rearward to block the sun's annoying rays. Yay!